Figure 1. Telephone Switchboard SB-55/F TC. (Telephone switchboard SB-55A/FTC is identical except that it includes a switch located on the wpper right front panel for controlling the heater units.).Historic68 pagesComms Signal
a make contact of the line jack to com- plete the circuit to ground for the oper- ation of relay 2. A make contact of relay 2 completes the trunk loop through windings (8-7 and 6-5 in series) of the repeating .coil to signal the distant…Historic120 pagesComms Signal
1. Scope a. This section lists items supplied for initial operation and for running spares. The list in- cludes accessories, parts, and material issued as part of the major end item. The list includes all items authorized for basic…Historic60 pagesComms Signal
Section GENERAL 1. Scope a. These instructions are published for the infor- mation and guidance of the personnel to whom this equipment is issued. They contain information cov- ering the installation, operation, maintenance, and repair of…Historic84 pagesComms Signal
1. Scope a. This manual covers field and depot main- tenance for Telephone Terminal AN/TCC-7. It includes instructions appropriate to third, fourth, and fifth echelons for troubleshooting, testing, repairing and alining the equipment,…Historic721 pagesComms Signal
Covers carrier multiplex telephone equipment AN/TCC-13, AN/TCA-1, and AN/TRA-10, including description, operation, and maintenance.Historic612 pagesComms Signal
Note. (Added) The basic manual covers Manual Telephone Switchboard SB-249/TTC, serial numbers 1 through 321, and Trunk Relay Telephone Circuit TA-226/TTC, serial numbers 1 through 107. Manual Telephone Switchboard SB-249/TTC, serial…Historic240 pagesComms Signal
WARNING HIGH VOLTAGE is used in the operation of this equipment DEATH ON CONTACT may result if personnel fail to observe safety precautions Be careful not to contact high-voltage connections or 200-volt input con- nections when working on…Historic202 pagesComms Signal
To prevent the enemy from using or salvaging this equipment for his benefit. WHEN—When ordered by your commander. 1. Smash—Use sledges, axes, handaxes, pickaxes, hammers, crow bars, heavy tools. 2. Cut—Use axes, handaxes, machetes. 3. Burn…Historic43 pagesComms Signal
Section I. 1. General a. Teletypewriter Sets AN/TGC-1 and AN/TGC-1A are complete teletypewriter sets designed for use in comcenters (communications center) and tape-relay stations. Each unit in- cludes facilities for sending, receiving,…Historic260 pagesComms Signal
This manual supersedes TM 11-2206, dated 26 June 1944, and 29 September 1944 SECTION DESCRIPTION 1. GENERAL. a. Telegraph Terminal TH-1/TCC-1 (figs. 1, 2, and 3) is designed to provide two-way voice-frequency carrier telegraph communica-…Historic136 pagesComms Signal
5. Description (figs. 1 and 2) a. Gene1·al. Test Set TS-2 (*) /TG is a selfcontained unit, 23 inches long, 17 inches high, and 14 inches deep overall. It weighs 70 pounds. The test set is mounted on a base casting which is attached to a…Historic68 pagesComms Signal
Teletype model 15 p is fixed station communication equipment. schange typewritten p sither typ rd. which i: sake ponents, thereby both The tabl nd cushion thHistoric425 pagesComms Signal
moving in the direction of motor rotation. If the motor speed is too slow, the spots will appear to move in the opposite direction. (3) Speed adjustment. To adjust the speed of a governed motor in a transmitter- distributor, stop the motor…Historic220 pagesComms Signal
Section I. DESCRIPTION I. General a. Teletype model 14 typing reperforator is a motor-driven device for receiving and, when equipped with a keyboard base, transmitting messages in the form of electrical impulses and recording the messages…Historic387 pagesComms Signal
Section GENERAL 1. Scope a. These instructions are published for the information and guidance of the personnel to whom this equipment is issued, They contain descriptive information for the installa- tion, operation, maintenance, and…Historic70 pagesComms Signal
Covers Telegraph-Telephone Terminal AN/TCC-14, providing simultaneous telegraph and telephone service over a single circuit.Historic146 pagesComms Signal
WARNING HIGH VOLTAGE is used in the operation of this equipment. DEATH ON CONTACT may result if personnel fail to observe safety precautions. viiHistoric222 pagesComms Signal
Section GENERAL 1. Scope This technical manual contains the necessary information for the installation, operation, main- tenance, and repair of Radio Sets AN/FRC-27 and AN/TRC-34. Both radio sets are identical with the exception that Base…Historic212 pagesComms Signal
Google This is a digital copy of a book that was preserved for generations on library shelves before it was carefully scanned by Google as part of a project to make the world's books discoverable online. It has survived long enough for the…Historic17 pagesComms Signal
TM 11-231 1-8 SIGNAL CORPS SECTION I GENEKAL Paragraph Purpose 1 Description 2 Characteristics 3 Transportation 4 1. Purpose.—The radio sets SCR-178 and SCE-179 are intended for point-to-point and ground-to-plane communication between…Historic44 pagesComms Signal
Section Il. DESCRIPTION AND DATA 3. General Description Camera PH-545A/PF is portable, record-copying equipment that operates semiautomatically to photograph bound or unbound documents on either 35-mm (millimeter) or 16-mm nonperforated…Historic125 pagesComms Signal
TM 11-232 2-5 SIGNAL CORPS 2. Power.— a. Input. — (1) The primary source of power required to operate this equipment is derived from a component part of the radio set SCR-177-B. This component is power unit PE-4&-C, which comprises a…Historic175 pagesComms Signal
Start With The Right Holster
Get 10% off your first T.REX holster, access to behind the scenes content, exclusive articles, and product updates delivered to your inbox.