1-1. Purpose. (5) Modulus of rupture (flexural strength) for This manual provides criteria for the design of pavements for roads, streets, walks, and open storage areas at U.S. Army and Air Force installations. 1-2. Scope. This manual…Archive118 pagesEngineering
STANDARD PRACTICE FOR CONCRETE PAVEMENTS 1. Purpose. This manual provides information on the materials and construction procedures for concrete pavements. 2. Scope. This manual describes the constituents to be used in concrete, the…Archive55 pagesEngineering
TM 5-822-9/AFM 88-6, Chap.10 2 proper conditions are provided as described herein. Generally pavement repairs with epoxy materials shall not be initiated unless the air and pavement temperatures are above 40 degrees F and rising. Class A…Archive15 pagesEngineering
TM 5-823-4 CHAPTER 1 GENERAL 1-1. Purpose. Runway and taxiway markings are essential for the safe and efficient use of airfields and heliports, and their effectiveness is dependent upon proper markings and maintenance to maintain an…Archive42 pagesEngineering
1-1. Purpose This manual provides guidance for dust control methods and materials that can be used successfully at airfields and heliports to stop dust from forming naturally or as a result of man's activities and to control dust in areas…Archive42 pagesEngineering
and scope. This manual establishes criteria for guidance of Corps of Engineers personnel in the planning and design of proposed military ports. It includes site selection and evaluation, layout of harbor facilities, coastal protection…Archive146 pagesEngineering
a. The Arctic and Subarctic may be defined in several different ways, depending on whether they are looked at from the point of view of astronomy, botany, physics, climatology, ocean navigation or other specialized field. For engineering,…Archive55 pagesEngineering
The importance of the proper selection of a construction site in arctic and subarctic regions cannot be over-emphasized. The type of data to be collected for the selection of a site is essentially the same as that used for engineering…Archive27 pagesEngineering
E. M. PART XV CHAPTER 3 October 1954 Part XV ARCTIC AND SUBARCTIC CONSTRUCTION CHAPTER 3 RUNWAY AND ROAD DESIGN 3-01. GENERAL. The construction of satisfactory roads and runways in permafrost areas is normally more difficult than in…Historic25 pagesEngineering
and scope. a. This manual provides criteria and guidance for design of foundations for structures for military facilities in arctic and subarctic regions. b. To facilitate the use of this manual, superscript numbers are used to refer to…Archive269 pagesEngineering
TM 5-852-5/AFR 88-19, Volume 5 1-1 CHAPTER 1 GENERAL 1-1. Purpose. uncommon for air temperatures to remain below -30 The purpose of this manual is to provide criteria and guidance for design of utility systems for military facilities in…Archive82 pagesEngineering
and scope . This manual contains criteria and methods for calculating the depths of freeze and thaw insoils,with consideration of the effects of other adjacent materials, for the design of military facilities in seasonal frost, arctic and…Archive62 pagesEngineering
WARNING Composition C2, C3, and C4 explosives are poisonous and dangerous if chewed or ingested. Their detonation or burning produces poisonous fumes-do not use as a heat source.Historic221 pagesEngineering
Operator's and organizational maintenance manual, including repair parts and special tools list, for the M180 cratering demolition kit and the M270 (inert) cratering training demolition kit.Archive85 pagesEngineering
Section I. GENERAL 1-1. Scope a. This technical manual describes general and technical information, and inspection and maintenance procedures for demolition materials. Information in this manual covers the responsibilities of direct and…Archive88 pagesEngineering
The Unified Facilities Criteria (UFC) system is prescribed by MIL-STD 3007 and provides planning, design, construction, sustainment, restoration, and modernization criteria, and applies to the Military Departments, the Defense Agencies,…Archive84 pagesEngineering
Engineer field manual, part I-VII: I. reconnaissance, II. bridges, III. roads, I·Army·1917
This manual is one of a series now being published, primarily for U.S. Army Special Forces, that deals with subjects pertaining to destructive techniques and their applications to targets in guerrilla and unconventional warfare. The series…Historic159 pagesEngineering
TM-9-1375-213-34&P Direct & General Support Maintenance Manu·Army·1996
Section I. GENERAL 1-1. Scope a. This technical manual describes general and technical information, and inspection and maintenance procedures for demolition materials. Information in this manual covers the responsibilities of direct and…Archive88 pagesEngineering
Wire entanglements : addenda no. 1 to engineer field manual·Army·1918
The purpose and objective of this manual is as follows: a. Purpose. This manual, which is a new one in the structural engineering design series, is to provide design guidance for structures of various types to resist blast loadings.…Archive358 pagesEngineering
1. The NAVFAC P-1100, Expedient Repair of Utility Systems Manual, identifies materials, equipment, and procedures to provide for the rapid restoration of utilities during wartime. Techniques are provided for quick temporary repair, or the…Archive49 pagesEngineering
This handbook describes various welding materials and techniques available to the SEABEE welder. The emphasis is placed upon interchangeability of materials ordinarily found in the Naval Construction Forces Table of Allowance. Although…Archive215 pagesEngineering
Ship Salvage, Harbor Clearance and Wreck Removal oftentimes require extensive underwater cutting and welding. The lack of recent fleet experience in these areas dictates the need for a manual that incorporates state of the art equipment…Archive200 pagesEngineering