WARNING The M240 Series Machine Guns must be inspected and gaged at least once annually for safety and serviceability. Initial gaging is required one year from receipt of the weapons. Air Force users refer to inspection requirements in Air…Archive333 pagesMarksmanship Weapons
TM 9-1005-224-24P ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST (INCLUDING DEPOT MAINTENANCE REPAIR PARTS) Section I. INTRODUCTION 1. SCOPE. This RPSTL lists and authorizes spares and…Archive88 pagesMarksmanship Weapons
Operator's and organizational maintenance manual, including repair parts and special tools lists, for the Caliber .45 M3 and M3A1 submachine guns.Archive61 pagesMarksmanship Weapons
3. EXPLANATION OF BLOCKS AND COLUMNS (DA FORM 2062). Refer to DA PAM 710-2-1, chapter 6. Additional information required to complete DA Form 2062 is listed below: a. Hand receipts shall identify the accounting requirement status of all…Archive11 pagesMarksmanship Weapons
Keep the weapon aimed on target until the gun is cleared. Don't let anybody get in the way of the barrel. Clear the gun whenever you don't intend to fire. Then, eyeball the chamber to make sure it's empty. Let a hot weapon that stops…Archive53 pagesMarksmanship Weapons
TM 9-1005-237-23&P 1-7. DIFFERENCES BETWEEN MODELS. (cont) a. The M6 Bayonet-knife is used on the 7.62-mm M14 rifle series. The M7 Bayonet-knife is used on the 5.56-mm M16 rifle series and the M4 Carbine. The two models cannot be…Archive102 pagesMarksmanship Weapons
Operator's manual for the M16 and M16A1 rifles: operation, maintenance, and troubleshooting (1990 reprint with changes).Archive154 pagesMarksmanship Weapons
ARMY TM 9-1005-249-23&P AIR FORCE TO 11W3-5-5-24 COAST GUARD COMDTINST M8370.9 HOW TO USE THIS MANUAL Read this manual carefully before performing required maintenance. This manual will be referred to for Inspection/Maintenance and Repair…Archive233 pagesMarksmanship Weapons
Section GENERAL 1-1. Scope. millimeter machine gun helicopter' armament a. This manual contains information and in- subsystems M23 (fig 1-1), M24 (fig 1-2), and M41 structions for operation and maintenance of 7.62 (fig 1-3). WE 10700A,…Historic56 pagesMarksmanship Weapons
Provides operation and maintenance information and instructions for the 7.62mm door-mounted lightweight machine gun helicopter armament subsystems XM23 (used on UH-1D helicopters) and XM24 (used on CH-47A helicopters), including the XM60D…Historic39 pagesMarksmanship Weapons
Code Explanation G Major assemblies that are procured with PEMA funds for initial issue only as exchange assemblies at DSU and GSU level, will not be stocked above DS and GS level or returned to depot supply level. (2) Maintenance Code.…Historic38 pagesMarksmanship Weapons
Operator's (crew) manual for the towed 20mm air defense artillery gun M167A1, covering operation of the M168 cannon, AN/VPS-2 radar set, and associated ammunition and equipment.Historic297 pagesMarksmanship Weapons
WARNING Warning. The fairing assembly must be installed for all weapon firing missions, since inflight without ram air duct may result in damage to aircraft tail rotor. Warning. When the GUN NOT CLEARED light is extinguished, the weapon…Archive114 pagesMarksmanship Weapons
ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST Section I. INTRODUCTION 1. Scope. This manual lists repair parts, special tools, and support equipment required for the performance of organizational maintenance of the M27…Archive39 pagesMarksmanship Weapons
WARNING Warning: Do not attempt to troubleshoot a loaded weapon. Be sure no ammunition is present in any subsystem component before energizing the system. Warning: Clear the weapon before starting inspection. Point weapon in a safe…Archive91 pagesMarksmanship Weapons
Aviation intermediate and depot maintenance repair parts and special tools list for the 7.62mm high rate helicopter machine gun armament subsystem M27E1, used on OH-6A and OH-58A helicopters.Archive109 pagesMarksmanship Weapons
Read this manual carefully before handling, loading, or operating the pistol. Do not point pistol at personnel when loading, clearing, or firing as this could result in injury to, or death of, personnel. For safety considerations, the…Archive120 pagesMarksmanship Weapons
ARMY TM 9-1005-319-23&P AIR FORCE TO 11W3-5-5-42 WARNING ALL WARNINGS in this technical manual pertain to both the rifle and the carbines unless otherwise specified. Before starting an inspection, be sure to clear the rifle. Do not pull…Archive325 pagesMarksmanship Weapons
2 Page Cover. Add "CARBINE, 5.56-MM, M4A1, (1005-01-382-0953)" to cover. Page 1. ALL WARNINGS in this technical manual pertain to all weapons unless otherwise specified. Change the word rifle to "weapons", in all the warnings unless…Archive176 pagesMarksmanship Weapons
ARMY TM 9-1005-319-23&P AIR FORCE TO 11W3-5-5-42 WARNING ALL WARNINGS in this technical manual pertain to both the rifle and the carbines unless otherwise specified. Before starting an inspection, be sure to clear the rifle. Do not pull…Archive325 pagesMarksmanship Weapons
Page b, add the following WARNING: WARNING Hearing protection is required for the user and all adjacent personnel on firing range, when using M585 Cartridge. Page 2-22, add the WARNING, same as above. Page 4-0, add the WARNING, same as…Archive95 pagesFires
Page b, add the following WARNING: WARNING Hearing protection is required for the user and all adjacent personnel on firing range, when using M585 Cartridge. Page 2-20, add the WARNING, same as above. Page 4-1, add the WARNING, same as…Archive107 pagesFires
Double loading of mortar ammunition has resulted in catastrophic accidents. Loading a mortar weapon with two men (alternately) can be very dangerous and could prove fatal. Even with one-man loading, double loading can occur. This is…Archive265 pagesFires
TM 9-1015-200-20&P 1-8. LOCATION AND DESCRIPTION OF MAJOR COMPONENTS. A CANNON ASSEMBLY. The barrel is an externally threaded tube, closed at one end by a base cap that locks into the socket cap of baseplate. The cannon is used to fire…Historic76 pagesFires
TM 9-1015-200-30&P 1-8. LOCATION AND DESCRIPTION OF MAJOR COMPONENTS. A CANNON ASSEMBLY. The barrel is an externally threaded tube, closed at one end by a base cap that locks into the socket cap of baseplate. The cannon is used to fire…Historic87 pagesFires
Hand receipt manual providing a preprinted DA Form 2062 listing of accountable Basic Issue Items (BII) and Additional Authorization List (AAL) items related to the 105mm towed light howitzers M101 and M101A1.Archive17 pagesFires
1. Scope. This publication provides an overprinted DA Form 2062 (Hand Receipt) which lists the contents of Components of End Item (COEI), Basic Issue Items (Bll); and Additional Authorization List (AAL) items related to MORTAR, 4.2-INCH,…Archive15 pagesFires
TM 9-1015-215-20&P 1-8. LOCATION AND DESCRIPTION OF MAJOR COMPONENTS. MORTAR BASEPLATE STANDARD ASSEMBLY ROTATOR ASSEMBLY ASSEMBLY MORTAR CANNON M30. Fires ammunition and controls the direction of the projectile flight path. SIGHTUNIT M53…Archive68 pagesFires
TM 9-1015-215-30 STANDARD ASSEMBLY ROTATOR ASSEMBLY MORTAR BRIDGE BASEPLATE ASSEMBLY 1-8. LOCATION AND DESCRIPTION OF MAJOR COMPONENTS. M30 MORTAR CANNON. Fires ammunition and controls the direction of the projectile flight path. M53…Archive116 pagesFires
TM 9-1015-223-12 Section II. EQUIPMENT DESCRIPTION 1-6. EQUIPMENT CHARACTERISTICS, CAPABILITIES, AND FEATURES. a. Characteristics. (1) Provides infantry with direct fire artillery capability. (2) Designed for antitank and antipersonnel…Archive163 pagesFires
Start With The Right Holster
Get 10% off your first T.REX holster, access to behind the scenes content, exclusive articles, and product updates delivered to your inbox.