The information contained irf restricted documents and the essential characteristics of restricted materiel may be given to any person known to be in the service of the United States and to persons of undoubted loyalty and discretion who…Historic32 pagesComms Signal
HE Manual of Radio Frequency Measurements is writ- ten principally around the types 100-A and 160-A Q- Meters. The same general measurement technique described in the Manual is also applicable to the type 170-A. Special pre- cautions…Historic52 pagesComms Signal
SECTION I. DESCRIPTION 1. PURPOSE AND USE. Test set (Espey model 100), hereafter referred to as "the test set" is a multi-range combination test instrument designed to measure voltage, current, and resistance. a. D-c Voltage Measurements.…Historic64 pagesComms Signal
1. Scope a. This appendix lists items supplied for initial operation and for running spares. The list includes tools, accessories, parts, and material issued as part of the major end item. The list includes all items authorized for basic…Historic108 pagesComms Signal
4. PACKAGING DATA. Each Vibrator Pack PP-68/U is packed in an individual card board carton 12-V2 inches high, 10 Miches wide, and 10 inches deep. The weight of each packed unit is 24-Vfc pounds. The spare, vibrator is wrapped in corrugated…Historic43 pagesComms Signal
In case of electric shock, shut off the high voltage at once and ground the circuits. If the high voltage cannot be turned off without delay, free the victim from contact with the live conductor as promptly as possible. Avoid direct…Historic256 pagesComms Signal
MAST BRACKET f5b-A Figure 4. Electrical Equipment Shelter S-56A/G, front oblique view. mounting bracket. Two Mast Brackets MP- 50-A, which support the receiving antennas, are secured to the front wall of the shelter. Mast Base Bracket…Historic124 pagesComms Signal
TM 11-2650 C1 TECHNICAL MANUAL MODULATOR MD-69/FRT CHANGES No, 1 TM 11-2650, 19 November 1945, is changed as follows: Title is changed to read: Modulator MD-69/ FRT. 32. Relays (Superseded) a. The proper operation of the relays in the aux-…Historic129 pagesComms Signal
1. General a. This section assigns maintenance functions and repair operations to be performed by the lowest appropriate maintenance echelon. b. The columns are as follows: (1) Part or component. This column shows only the nomenclature or…Historic91 pagesComms Signal
Vacuum tube voltmeter (Hickok model 110-B) is an electronic test unit used to measure either d-c (direct-current) or a-c (alternatingcurrent) voltages. Readings are registered on a single meter which has five scales. The circuits are…Historic89 pagesComms Signal
SECTION I. DESCRIPTION 1. GENERAL. Keyer KY-7/FRT (fig. 1) is a unit designed to adapt any type of keyed radio transmitting equipment to tone-keying operation. The keyer is intended for use with a 500-ohm keying line. This line feeds a…Historic67 pagesComms Signal
SECTION I DESCRIPTION OF CRYSTAL TEST SET TS-314/FSM-l ' 1. GENERAL. Crystal Test Set TS-314/FSM-1 (Ray Jefferson Activity and Fre quency Test Unit AF-30) is an instrument designed for checking the activity and frequency of quartz crystals…Historic95 pagesComms Signal
(WARNING) HIGH VOLTAGE is used in the operation of this equipment. DEATH ON CONTACT may result if personnel fail to observe safety precautions. Be careful not to contact high-voltage connections or 115-volt input con- nections when working…Historic80 pagesComms Signal
Covers Radio Sets SCR-210 and SCR-245 series, including description, employment, operation, and functioning of components.Historic159 pagesComms Signal
TM 11-273 RADIO SETS SCR-193-A, ETC. 1-4 1. Purpose.— Radio sets SCE-193-A, SCR-193-B, SCR-193-C, SCR-193-D, and SCR-193-E are designed for installation in vehicles for the purpose of providing intervehicular communication whether the…Historic123 pagesComms Signal
In case of electric shock, shut off the high voltage at once and ground the circuits. If the high voltage cannot be turned off without .delay, free the victim from contact with the live conductor as promptly as possible. Avoid direct…Historic126 pagesComms Signal
Section I. GENERAL 1. Scope a. This technical manual contains instructions for the installation, operation, and organizational maintenance of Radio Sets AN/VRC-8, —9, and -10. The information is intended primarly for operators and…Historic122 pagesComms Signal
Covers Receiver-Transmitters RT-66/GRC, RT-67/GRC, and RT-68/GRC, including operation, maintenance, and modification work orders.Historic28 pagesComms Signal
Section GENERAL 1. Scope a. This technical manual contains instructions for the installation, operation, and organizational maintenance of Radio Sets AN/VRC-13, -14, and -—15. The information is intended primarily for operators and…Historic156 pagesComms Signal
AGO 313A WARNING HIGH VOLTAGE is used in the operation of this equipment. DEATH ON CONTACT may result if personnel fail to observe safety precautions.Historic137 pagesComms Signal
Supplement covering Radio Sets AN/VRC-19, -19X, and -19Y, with changes and supplementary information to the basic technical manual.Historic14 pagesComms Signal
To prevent the enemy from using or salvaging this equipment for his benefit. WHEN—When ordered by your commander. HOW — 1. Smash—Use sledges, axes, handaxes, pickaxes, hammers, crow- bars, heavy tools, etc. 2, Cut—Use axes, handaxes,…Historic180 pagesComms Signal
TM: n-302 C 1 TECHNICAL MANUAL, 10y4. (Added.) Power units PE-HF-43 and PE-HG-43.— These units are identical with power units PE-HD—13 and PEHE-43. All information in paragraphs 1 to 10 inclusive pertaining to power units PE-HD-43 and…Historic87 pagesComms Signal
TM 11-303 Pars. 1-3 This manual supersedes War Department Training Circular 69, 19 May 1943 SECTION I DESCRIPTION 1. PURPOSE. Test Sets I-56-C, I-56-D, I-56-H and 1-56 J, referred to in this text as Test Set 1-56- (*), are electrical…Historic111 pagesComms Signal
5. Adapter RS-259 This adapter is used for aligning Radio Sets SCR-509-(*), SCR-510- (*), and SCR-610-C*). It plugs into the transmitter Battery BA-39, thereby placing a 500-ohm, 5-watt resistance in series with the highvoltage (h-v) lead.…Historic51 pagesComms Signal