Surefire SR09-D-IT Insight/Scout Dual Pressure Pad

Ships in 1-8 business days
This product is regulated by ITAR. It can only be shipped in the USA.

This dual accessory switch provides remote momentary-on activation, either separately or simultaneously, for two weapon-mounted illumination tools—a Surefire WeaponLight and an ATPIAL or DBAL laser. Separate plug-in cables connect each device to the switch platform, where two pressure-pad switches are integrated with a single snap-on clamp for easy attachment to your firearm’s Picatinny rail forend. The 9-inch switch cable (SR09-D-IT) works with most rifle/carbine applications; a 7-inch cable is available from Surefire (SR07-D-IT). The entire unit is weatherproof, including the O-ring-sealed plugs.

The Dual Pressure pad is our preferred solution to activating a light/laser on a carbine. Extremely intuitive, easy to setup, and proven Surefire quality.

The Dual Pad is also compatible with the B.E Meyers MAWL.
9″ version on this 416 with M600V and PEQ15.
Attached to the side of a 416 rail. While not the best location to run one of these, it can work if the real estate isn’t there for top-mounting.
ATPIALC + M600DF + Dual Pressure Pad + DS00.
Assembled ATPIALC + M600DF + Dual Pressure Pad + DS00.
ATPIALc + M600V + Dual Pressure Pad + Standard Rear Cap Host.
ATPIALc + M600V + Dual Pressure Pad + Standard Rear Cap Host.
Dual pressure pad hooked up to the DS00 rear cap.
This dual pad was shaved down in the front to mount closer to the PEQ15.
Mounted to a Daniel Defense RIS II rail. Sweet CQBR setup.
This Dual Pad was trimmed on the front so it could fit closer to the PEQ15.
Trimming a Dual Pad down is especially helpful on a shorter gun like a 300BLK or a 10.3.
Boom. Slick setup.
You can trim the sides of the pressure pad if need be for uses with quad rails. This one is trimmed down to fit on this 416.